ETA 2824 to NH35 case adapter kit (for Seiko dial with date wheel overlay)
Specifications
| All Returns Accepted | ReturnsNotAccepted |
| Brand | Unbranded |
| Compatible Brand | Sellita |
| Type | Movement holder |
| Compatible Model | NH35 |
| Material | PLA |
With this kit, you can build a high-beat (28,800 bph) watch based on the ETA 2824-2 or the Sellita SW200-1 or one of the many Chinese-made ETA 2824-2 clones such as the HKPT PT5000 or Sea-gull ST2130 or Peacock SL3000 using any of the widely-available cases compatible with the Time Module (TMI) or Seiko Instruments Inc. (SII) NH35 movement. This kit is for using an OEM Seiko/NH35 dial which requires a date wheel overlay (DWO) installed on the 2824-2 movement for the date numerals to properly align in the center of the date window on the dial. NOTE:NO MOVEMENT IS INCLUDED IN THIS KIT. Any depictions of a movement or assembly equipment are for illustrative purposes only. If you need a 2824-2 movement with an NH DWO pre-installed, see my other listings. If you want to use a standard ETA dial or a no-date OEM Seiko or NH35 dial with a date window, see my other listings for the applicable case adapter kit. I also have listings for 2824-2 movements that have been modified to remove the date window as well as the ghost crown position. ITEMS INCLUDED IN KIT 1. Movement holder3D-printed, custom designDimensionally similar to the standard NH35 built-in gray plastic movement holderAdds headroom underneath dial for NH DWOSupports aftermarket NH3X dials as well as NH3X-compatible OEM Seiko dialsProvides large surface area for the use of optional dial dots to hold dial flush with holderNOTE: In order to add headroom for the DWO underneath dial, the spacer was designed to slightly increase the stem height of the movement. This results in a lower hand height above the dial. If you intend to use a dial with a tall, applied logo or indices and need additional height of the hour hand, it is recommended that you use 2824-2 movement with H3 height or taller wheels. Please see my other listings for H3 modified movements with DWO pre-installed. The dial feet slots on the movement holder are positioned for NH3X dials. Most OEM Seiko dials have identical dial feet position as NH3X dials, but some OEM dials do not. Please check if your OEM Seiko dial is compatible with NH35 movements before purchasing this kit. These dial feet slots have a depth of approximately 1 mm. They could not be made any deeper, as they would run into the main plate of the movement otherwise. In order to use dials without breaking off the dial feet completely, they can be trimmed down to appropriate length (less than 1mm). As the movement holder is 3D-printed, there could be some artifacts common in 3D-printed parts such as minor wall separation or stringing. These do not impact the integrity of the holder. 2. Case clamps and screws (for mounting movement in holder) 3. Dial dots (x6) NOTE: Use only if OEM Seiko and NH35 dials do not stay seated to movement by friction. 4. Spacer ring NOTE: This spacer ring optionally sits between the movement+holder and the case back. This spacer allows the case back to hold down the dial firmly against the case's rehaut and eliminates any z-axis play of the entire movement and dial assembly.
